This Universal Parts 90-inch throttle cable restores a light, smooth throttle pull on compatible carbureted or cable-operated EFI scooters. Its long sleeve gives you the reach needed for large-chassis scooters and custom builds, while barrel ends connect to matching throttle controls, carburetors and EFI throttle bodies. A multi-strand steel inner wire and low-friction polymer liner help keep your throttle action crisp and consistent.
Features
-
90-inch sleeve: Provides routing reach for compatible large-chassis and long-wheelbase scooters.
-
Carburetor and EFI applications: Works with matching barrel-connector mechanisms, including cable-operated EFI throttle bodies.
-
Multi-strand steel wire: Resists stretching and fraying.
-
Low-friction polymer liner: Helps maintain a light, smooth pull.
-
Adjustable engine-end fitting: M10 threaded adjuster with lock nuts and a rubber boot.
-
Angled end fittings: A 60° bend at the throttle side and a 30° bend at the carburetor or throttle-body side aid cable routing.
Specifications
-
Brand: Universal Parts
-
Part number: 100-186
-
Additional reference: 2091
-
Sleeve length: 90 inches, 2286mm
-
Inner-wire travel: Approximately 4½ inches
-
Throttle-side bend: 60°
-
Carburetor / throttle-body-side bend: 30°
-
Engine-end adjuster: M10 threaded
-
Cable ends: Barrel connectors
-
Inner wire: Multi-strand steel
-
Liner: Low-friction polymer
-
Engine-end protection: Rubber boot
-
Country of origin: China
Model Fitment
| Application |
Fitment requirements |
| CVK / PD24J and compatible GY6 carburetors |
Matching barrel ends, adjuster mounting, cable travel and routing length |
| Cable-operated EFI throttle bodies accepting barrel connectors |
Matching barrel dimensions, cable bracket or adjuster mounting, required travel and routing length |
| Lancer 150, Phantom R4i, Quantum 150 and Matrix 150 |
Configuration requiring this 90-inch sleeve and matching end fittings |
| BMS, Jonway, Roketa and ZNEN 150cc touring models |
Matching throttle mechanism, fittings and routing |
| Full-size 125cc, 150cc and 170cc GY6 scooters using QMI152 / QMJ157 platforms |
Matching cable connections and 90-inch sleeve requirement; engine code alone does not establish cable fitment |
| Custom stretched Ruckus clones and GY6 engine-swap builds |
Compatible controls and engine-end mechanism with suitable routing length |
Compare your existing cable's sleeve length, barrel ends, threaded fittings, bend angles and travel before ordering. Route the cable without sharp bends or overly tight ties. After installation, confirm smooth throttle opening and return through the full steering range; the idle should not rise as the handlebars turn.
